A full re-roof on a multi-gable Camas hillside home - one of the trickier roof geometries in the county, with a steep main pitch, multiple dormer cuts, and a chimney to flash around.
Scope of work
We tore the existing composition shingles down to the deck, inspected and replaced any compromised sheathing, and re-built the roof system from the underlayment up. Architectural asphalt shingles in a dark slate tone - durable, PNW-appropriate, and a clean look against the lighter siding.
Step flashing was replaced wholesale (we don’t reuse old flashing on a tear-off) at the chimney and along every dormer cheek. Valleys got an additional run of ice & water shield underneath the synthetic underlayment for redundancy.
Why the gutter ran with the roof
The existing aluminum gutters were oversized but undersloped and had pulled away from the fascia in a few spots. Doing the re-roof without re-doing the gutters would have meant pulling new gutters off old fascia later. We took the chance to fabricate a new seamless aluminum run on site, in a finish that complements the home’s trim color. Downspouts were resized and extensions added to push water further from the foundation.
What we’d do again the same way
The combination of full tear-off + new underlayment + architectural shingle is the right call on a roof this age and pitch. We don’t recommend layovers (going over old shingles) on PNW homes - the underlayment matters too much to skip.


