Camas, WA
Deck Builder Camas, WA - Hillside Decks, Composite & Covered Builds
On a sloped Camas lot the deck is an elevated structure, and most of the cost sits in footings and posts you will never look at again. Free design consult, and we will explain what you are paying for.
- 5/5 from 30+ verified Google reviews
- Licensed WA & OR · bonded · insured
- Free written estimate
No trip charge, and no pressure to buy more than your house needs.
Deck building in Camas at a glance
Quality Master builds decks across Camas, WA, and most of them go on lots that drop away behind the house. Prune Hill, Lacamas Heights, and Grass Valley decks are typically elevated structures on sloped ground, which puts the engineering in the footings, posts, and beam spans rather than in the surface boards. We build composite and cedar, install cable and glass-panel railing that does not block the view, and tie covered decks into the existing roof so the flashing is right. Decks above 30 inches need a permit and we pull it.
- Neighborhoods: Prune Hill, Lacamas Heights, Grass Valley, Fern Prairie, Camas Meadows
- Typical build: elevated deck on sloped ground, not an at-grade platform
- Materials: composite (Trex, TimberTech), western red cedar, pressure-treated framing
- Railing: cable and glass-panel where a view is the point of the deck
- Permits: City of Camas, and anything above 30 inches goes through plan review
Manufacturer-certified, and licensed where you live
Licensed & verifiable
WA QUALIML786JF · OR CCB 243945. Check us at Washington L&I.
Permits in Camas
Camas runs permits through the City's Building Department, separate from Clark County.
Owner on every job
Victor Santiago walks each project before we call it finished.
Decks in Camas
Decks Camas, WA: the part you do not see is the part that matters.
Camas lots slope. That single fact drives almost every decision on a deck here. Where a flat Orchards or Salmon Creek backyard takes an at-grade platform on short posts, a Prune Hill or Lacamas Heights deck is an elevated structure, sometimes eight or ten feet off grade at the outboard edge, with footings that have to be dug and poured to bear on undisturbed soil rather than on fill.
That means the money and the risk both sit below the decking. Post size, beam span, joist spacing, and the hardware at every connection are what keep an elevated deck safe over decades, and they are also the parts a homeowner never sees again after the boards go down. We would rather spend the conversation there than on board color. Anything above 30 inches goes through City of Camas plan review, which adds calendar time and is worth building into your expectations early rather than discovering in week two.
Railing is where Camas differs from everywhere else we build. These are view lots and the view is usually the reason the deck exists, so a solid or heavily-picketed rail defeats the purpose. Cable and glass-panel systems keep the sightline open while meeting the same code requirements. They cost more than composite top-rail with balusters and on a view lot they are almost always worth it.
Covered decks are the other common Camas request, and they are the one place a deck becomes a roofing job. Tying a cover into an existing roofline means cutting into finished shingles and flashing a new intersection properly, which is the detail most deck-only builders leave for someone else. Our Camas roofing crew handles that tie-in on the same job. Material trade-offs, the composite versus cedar maintenance math, and railing options in full are on the deck building and materials page.
Real Projects
Recent Projects in Camas
1 documented job in this area
Before you hire anyone
What Camas homeowners ask us before signing.
Do I need a permit, and who deals with it?
Anything above 30 inches off grade generally does, plus most covers. We confirm what your specific design needs with the right office, pull it, and coordinate the inspections. You are not the one on the phone to the building department.
Is the attachment to my house going to be safe?
The ledger is the connection that hurts people when it fails, so we inspect the framing behind it rather than assuming, flash it properly, and use the right hardware. Where the existing framing is not sound we build freestanding instead and tell you why.
What happens to my yard while you build?
Footings mean digging and we are honest about that. We protect what we can, keep the material staged in one place rather than spread across the lawn, and put the ground back. Anything that cannot be protected we point out before we start.
Are you licensed here?
Washington QUALIML786JF and Oregon CCB 243945, bonded and insured. Both are public record. Structural work outdoors is exactly where an unlicensed contractor costs you the most, so check.
Camas decks FAQ
Deck builder Camas, WA questions, answered.
Why does a Camas deck cost more than the same size deck elsewhere in Clark County?
Because it is usually not the same deck. On a sloped Prune Hill or Lacamas Heights lot the structure is elevated, which means deeper footings, taller posts, longer beam spans, and more hardware than a flat-lot platform of identical square footage needs. The decking you walk on is the cheaper half of an elevated build.
Do I need a permit for a deck in Camas?
Anything above 30 inches off grade does, and on a sloped Camas lot most decks clear that easily. Camas runs its own Building Department separate from Clark County, and structural work goes through plan review, which adds time beyond a simple over-the-counter permit. We pull it and coordinate the inspections.
What railing works on a view lot?
Cable or glass-panel. Both meet the same code requirements as a picketed rail while leaving the sightline open, which matters when the view is the reason the deck is there. They cost more than a composite top-rail with balusters. On a Camas view lot that premium is usually the best money on the project.
Composite or cedar for a Camas deck?
Composite if you do not want to be sealing it every two to three years, which is what western red cedar needs to survive Pacific Northwest wet. Cedar if you want the look and accept the maintenance cycle. On elevated decks there is a second argument for composite: refinishing a deck ten feet off the ground is a harder and more expensive chore than refinishing one you can step onto from the lawn.
Can you build a covered deck that ties into my roof?
Yes, and that tie-in is the part worth being careful about. A cover has to cut into the existing roof and flash a new intersection, and a bad flashing detail there leaks into the wall rather than onto the deck where you would see it. We do the roofing and the deck with the same company, so nobody is pointing at anyone else if it ever weeps.
My deck framing is old but the boards are the problem. Can you just resurface?
Sometimes, and we will tell you honestly which it is. We pull a few boards and check the joists, the ledger attachment, and the post bases before quoting a resurface. On an elevated Camas deck the ledger and the post connections are where we are most likely to find something that rules it out, because those are the connections carrying the load.
More from Quality Master in Camas.
Roofing in Camas, WA
Roof replacement, repair, and storm damage across Camas, plus every other trade we run here.
Siding in Camas, WA
Open butt joints, soft trim, or you are simply tired of repainting every few years. We come out free, open a section so you can see what is behind it, and tell you whether this is a repair or a re-side.
Windows in Camas, WA
Haze between the panes that will not clean off is a failed seal, and on Camas Meadows-era houses it is rarely just the one window. We assess free and quote per opening, so you can see exactly where the money is.
Decks materials, methods and warranties
The full decks breakdown for Vancouver, WA and the whole service area.
Decks elsewhere in Clark County, WA
Decks elsewhere in Portland metro, OR
Deck Builder Camas, WA - free written estimate.
Camas, WA homeowners: call us or send a quick form, and we'll have someone out to measure and quote within a couple of days.